Super “T” - Thick consistency to fill gaps and voids on rough surfaces. Use to make invisible repairs on wooden stocks, and fill chips in clear finishes. Original Formula - ultra thin wicks into the smallest crack and bonds in only five seconds. Bonds almost instantly to leather, vinyl, rubber, wood, laminates, plastic, fiberglass and Kevlar. Quick bonding, industrial-grade, cyanoacrylate adhesives make short work of clear finish filling, fiberglass and wooden stock repairs, sight mounting and general shop work. Repairs Wooden Stocks, Fixes Gun Parts In As Little As Five Seconds We will continue to gather this information to assist our customers in making informed buying decisions, and will keep our website current with the latest information. This information, however, is not available for all items nor does it imply that foreign merchandise is of lesser quality. Many customers have asked us to show which products are made in America, and we’ve begun working with our vendors to identify them. Products marked with the Stars and Stripes are proudly made in the U.S.A. But with Hot Stuff, you don’t have to wait long. I went ahead and left it in the vice for another hour just to make extra sure. Then, I let it dry and harden completely which took only a few minutes. I didn’t want any excess glue interfering with the operation of the forearm and magazine tube later on. I had some Q-Tips handy and dipping one end in some solvent, I cleaned up the glue that had squished out of the crack on the inside of the wooden “tube” part of the forearm. Then I wrapped it in an old towel for some padding and placed in my vice, slowly tightening it down to ensure the crack was sealed firmly. This stuff is really strong!) All I had to do was brush the wood off a little bit to clear it of dust and then I carefully ran a small bead of the Hot Stuff down the piece. (Just don’t glue your fingers to whatever you’re working on. This is some pretty awesome glue and a very little of it goes a long way. I have some good strong Hot Stuff (#862-000-003). Since it had cracked the entire length of what little wood there was, I knew I’d need to glue it back together. This is the rounded section that the barrel is seated over. In the process of trying to get it taken off, I had cracked the inside groove of the wooden forearm. When I had been taking the gun apart in a previous article, the forend cap had been rusted in place. Several wraps with electrician’s tape works well. Make sure the stock is held tightly together as the pin is inserted and that there is no gap between the pieces. Here is Copy & Paste from Brownell's with details on a shotgun forearm crack repair. Coat the stock repair pins with Acraglas Gel and carefully tap them into place. Set up is key and don't get it on your fingers! You'll be glued to the wood. There will be no "glue line" if done correctly.the "glue line" is what you normally see with a crack repair. THIS IS CORRECT PRODUCT for a crack.there are three thicknesses of HOT STUFF.thinest for tiny crack etc. Brownell's HOT STUFF is the correct product.Do a google search to find.
0 Comments
Leave a Reply. |